Omnicron

The newest acrylic creation, designed and named by CJ Atkinson of Team 3yo3, the Omnicron. The entire yoyo has been designed with one thing in mind- long spin times from a plastic yoyo. I've beefed up the rims, while keeping center material low (Notice the "H-shape" of the yoyo, and the side "dish" cut-out.) Gone also, is the 1/4" axle. The omnicron sports OneDrop press in brass inserts, with a smaller diameter, M4-.7 axle, and uses spacers which house your choice of A, C, or D bearing. This means that since the inner race is smaller, it will be rotating at a slower speed, and it also is of less mass, which all equate to longer spin times.

Diameter: 52.07mm

Width: 40.64mm

Weight: 70 grams

Flow Groove Size: (3.15 deep, 2.02 width)mm

Bearing: A, C, or D, Stainless Steel, Pre-cleaned.

When ordering, in the comments write which size bearing you would like, and I'll machine your yoyo to that specification.

Options

Clear Polished $70.00 Bead Blasted $70.00 Dyed, Polished $70.00 Dyed, Bead Blasted $70.00 Colored, Polished $90.00 Colored, Bead Blasted $90.00

More pictures. I can make the Omnicron with the same finish and color options as the Acryllion and Cosmo, some examples are here.

Cosmo - Acryllion - Omnicron:

A few Colors I've done:

C Bearing Rainbow Omnicron

D Bearing Abalone Omnicron

Bead blasted

Gap view of the Omnicron, this sports an "A" (5x10x4)mm bearing:

Blue/Orange "C" bearing Omni

The axle system, note spacers and width of silicone groove.

C Bearing Omnicron, Special for Vendetta

BACK